Whittier Wood Furniture 747Wa Instrucciones De Montaje página 11

Fig. 16
ZA x 12
ZB x 12
16. Install the Adjustable Shelves (Na & Oa) using the Shelf Brackets (ZA) and #6 x 58" Undercut
Screws (ZB) at the desired locations. Make sure the front edges of each shelf is flush with the
front edge of either Vertical Divider (Aa). See Figures 16 and 16a.
ZD x 12
Hinge
Arm
ZD
ZD
Fig. 17
17. With the Doors (P) laying face down on a clean protected surface, place a Hinge (ZC) in each
large hole in the back of each door. For each Hinge (ZC), line up the screw holes in the hinge
with the pre-drilled holes in the door and insert #6 x 3/4" Overhead Screws (ZD). See Figure 17.
18. Holes are predrilled in each Side (Ca & Da) to mark the locations of the screws for each Hinge
Plate (ZE) and Hinge Spacers (ZL & ZM). Since it may be difficult to see these holes through
the hinge spacers, start a #7 x 1-1/2" Pan Head Screw (ZG) into each hole to make it easier
to align. Remove the screw and insert it through the Hinge Plate (ZE), Hinge Spacer 7/16" (ZL)
and Hinge Spacer – 5/8" (ZM). With the long arm facing out (arrow on the plate points out),
fasten each set in place with a #7 x 1-1/2" Pan Head Screw (ZG). See Figure 18.
Oa
Aa
ZC
Door
Na
Aa
Flush
ZG x 12
ZG
ZG
Fig. 18
Na / Oa
ZB
Fig. 16a
Side
5/8"
7/16"
ZM
ZL
ZE
06/11 — 747Wa — Page 11
ZA