Whittier Wood Furniture 747Wa Instrucciones De Montaje página 12

ZL & ZM
Hinge
ZE
2
Fig. 19a
19. To attach the door to the unit, slide the hinge arms onto the hinge plates as shown in
Figure 19a Tighten the screw marked '2' in Figure 19b to fasten hinge. The door may need
to be adjusted so that all the spaces between the door and the unit sides are equal. To adjust,
follow instructions in Figure 19b.
ZI x 4
Fig. 20a
20. Attach the Satin Handles (ZH) to the doors with #8 x 1" Machine Screws (ZI). See Figure 20a.
Attach Pads (ZJ) to the upper and lower corners of the doors where they will make contact
with the vertical divider. See Figure 20b.
Fig. 21
21. With the unit in its permanent location, rotate the Adjustable Glides (Y) as necessary to level
the unit. The doors may need some adjusting after leveling the unit. See Figure 21.
22. Once in place and level, install the Furniture Tipping Restraint (ZK). Carefully follow the
instructions on the package.
Page 12 — 747Wa — 06/11
Arm
ZC
Door
ZI
ZH
ZI
3
2
3
1
Fig. 19b
ZJ x 4
Fig. 20b
Side adjustment 4mm (5/32")
To move the door towards the side
panel, loosen screw '1' and tighten
screw '2'. To move the door away
from the side panel, loosen screw
'2' and tighten screw '1'.
Depth Adjustment 4mm (5/32")
Loosen screw '2' (just one turn),
adjust door to desired position,
and re-tighten screw.
Height Adjustment 4mm (5/32")
Loosen screw '3', adjust the door to
the desired position and re-tighten
the screw.
ZJ
ZJ