Home Decorators Collection 91122 Guía De Uso Y Cuidado página 13

Assembly - Attaching the Light Kit
2
Installing the bulbs and attaching the
glass bowl
WARNING: Allow the glass bowl to cool completely before
removing.
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
CAUTION: Over lamping the fan will result in the fan lights
shutting down until the proper wattage bulbs are installed.
Reset the lights by turning off the power, replacing the bulbs
with the correct wattage bulbs, and turn the power on.
□
Remove the finial (RR), glass holder (PP), hex nut (Q),
rubber washer (P), and glass bowl (R) from the light kit
assembly (G).
□
With power off, install the two bulbs (J) by twisting them
into the light bulb sockets. Position the glass bowl (R) over
the threaded nipple and pass the pull chain for the fan
through the pull chain guide (V V) on the side of the light kit
(G) to avoid the chain from touching the glass bowl (R).
□
Re-install the rubber washer (P), hex nut (Q), glass holder
(PP), and finial (RR) to the threaded nipple to secure the
glass bowl (R) properly.
□
Attach the pull chain extensions (BB).
1
Assembling the fan without light kit
□
Remove the three light kit mounting screws (QQ) from
switch cup cover (FF).
□
In order to use the fan without the light kit, remove the
switch cup cover (FF) from the top of the light kit fitter
assembly (G) by removing the center hex nut inside the
switch cup cover (FF), and then thread the switch cup cover
off of the threaded nipple on the top of the light kit fitter
assembly (G).
□
Press the plastic plug (CC) (provided) into the center hole of
the switch cup cover (FF).
□
Position the switch cup cover (FF) onto the bracket and
reinstall the light kit mounting screws (QQ).
G
J
R
P
Q
PP
RR
QQ
G
13
Please contact 1-800-986-3460 for further assistance.
F
V V
BB
F
FF
CC
HOMEDEPOT.COM/HOMEDECORATORS