KNOVA KN M-2509RC Manual Del Usuario página 11

ASSEMBLY
INSTALLING THE HOLD-DOWN CLAMP ASSEMBLY
(FIG. E, F)
Place the hold-down clamp assembly (1) in one of
the mounting holes (2) located behind the fence.
2
Fig. E
2
UNLOCKING THE SLIDE CARRIAGE (FIG. G)
After removing the saw from the carton, loosen the slide
carriage lock knob (1), located on the left side of the slide
carriage. When transporting or storing the miter saw,
the slide carriage should always be locked in position.
1
Fig. G
REMOVING AND INSTALLING THE BLADE
NOTE: The miter saw comes with the saw blade already
installed.
1
Removing the Blade (Fig. H, H-1, I, J)
1. Unplug the saw from the outlet.
2. Raise the cutting head to the upright position.
3. Remove the cover plate screw (2) with a Phillips
4. Raise the lower blade guard (1) to the uppermost position.
5. Rotate the cover plate (3) back to expose
6. Place the provided blade wrench over the arbor bolt (4).
2
Fig. F
7. Locate the arbor lock button (5) below the trigger switch
8. Press the arbor lock button (5), holding it in firmly while
10
WARNING
• Do not use a blade larger than 10 in.
in diameter. To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
• Make sure the blade is installed correctly and is tight
before operating saw.
screwdriver (Fig. H)
(Fig. H-1)
the arbor bolt (4). (Fig. H-1)
2
Fig. H-1
handle. (Fig. I)
turning the blade wrench clockwise. This will engage the
arbor lock allowing the arbor bolt to be loosened with the
blade wrench. Continue to hold the arbor lock button (5),
while turning the wrench clockwise to loosen the arbor bolt.
Fig. H
1
1
3
4