Before The First Operation; Safety Cut-Out - Kalorik USK JK 1 Manual De Instrucciones

BEFORE THE FIRST OPERATION

For the perfect taste, operate the jug kettle with fresh water in order
to clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.
OPERATION
Always remove the jug from the power base before filling it or
•
before any operation.
Raise the lid and fill the tank with fresh water paying attention not
•
to fill under the minimum mark and above the maximum mark in
the kettle.
Release the lid and make sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket and
•
switch on. The pilot light of the switch will come on, indicating
that the appliance is operating. If it does not come on, check if
the kettle is correctly positioned on the base and check if the
base is plugged in.
The jug kettle will switch off automatically when the water has
•
boiled. However, you can stop the appliance any time by putting
the switch in off position.
For instant reboiling, wait until water has cooled down and switch
•
on the appliance again.

SAFETY CUT-OUT

This jug kettle is protected with an automatic safety device if
•
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
In this case, switch off the appliance by putting the switch in OFF
•
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.
The kettle may then be used as normal.
•
5
USK JK 1 - 080215