Tools Required - Whittier Wood Products 238W Instrucciones De Montaje

238W, 239W & 251W 2-Door Kits
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Head Screwdriver, Scissors or Knife.
1. Use the compatibility chart below to determine location of the doors you wish to hang on
either your base or hutch.
Door Kit
238W, 239W
& 251W
P — Glass Retainer
FOR 239W ONLY:
2. The Glass Door Frames (A) come with the Glass (O) in place for security during shipping. It
is held in place by small pieces of retainer which should be removed with the glass prior to
finishing the doors.
Place the Glass Door Frames (A) on a clean protected surface and insert the Door Glass (O)
in the notch. Cut the Glass Retainer (P) into eight pieces equal to the length and width of the
glass for both doors. Lay glass retainer pieces flat on the glass and press notched edge into
the door frame along the glass. NOTE: Cutting the Retainer at a 45-degree angle will give
a more finished look.
CAUTION: DO NOT LEAN ON THE GLASS WHEN WORKING ON THE DOOR.
234W Wide
Bookcase Base
or
235W Wide
Console Base
USE WITH
236W Wide
4-Shelf Hutch
237W Wide
6-Shelf Hutch
FIG. 2A
Hutch or Base
Use predrilled holes
in top and bottom
locations.
Use predrilled holes in
top and center locations.
Cannot be used
together.
Hinge Plate Location
Scissors or Knife
FIG. 2B
238W, 239W, 251W — Page 3