simatherm IH 070 Manual De Instrucciones página 29

- Heavy workpieces (≥10 kg/22 lbs) that must be installed on
the top yoke should be supported until the yoke is in the correct
position on the right-hand side post. The heater may tip over if
the workpiece is not supported.
- The swivel body (2) can remain on the heater at all times.
• For workpieces with an internal diameter large enough to fit over
the inductive coil, follow these steps:
- Place the workpiece over the inductive coil using appropriate
lifting equipment.
- For best performance, adjust the position of the workpiece so
that the inductive coil is in the centre.
- Remove the protective film from the bright underside of the top
yoke before the first use.
- Position the top yoke so that it completely covers the top of
both vertical supports.
• For workpieces that do not fit over the inductive coil, follow these
steps:
- Choose the larger of the three yokes that fit through the internal
diameter of the workpiece.
- If necessary, remove the top yoke from the IH 070/090.
- Verify that the protective film has been removed from the
underside of the small or medium yoke if it is to be used for the
first time.
- Slide the workpiece onto the yoke that you have selected.
- Position the yoke on the IH 070/090 with the bright
underside resting evenly on the two vertical supports.
• If you will use TEMP MODE, plug the temperature probe into the
connector on the left side of the heater. Place the magnetic end of
the probe on the inner ring of the bearing or on the innermost
surface of the workpiece.
• Use the power switch on the left side to switch on the IH 070/090.
• Observe the self-test of the display and signal tone.
© simatec ag Induction Heater IH 070/090 29