Tabla de contenido
Publicidad
REPLACING THE BELT / SUSTITUYENDO LA CORREA
If the belt drive in the powerhead breaks or becomes worn, replace it as follows:
Si se corta o se desgasta la correa de transmision del cabezal electrico, cambiela de este
modo:
1.Unplug the vacuum cleaner and
loosen the two screws on the lower
housing of the powerhead.
2. Remove the upper housing of the
powerhead.
3. Remove the brush cover.
4. Detach and remove the beater brush.
5. Remove the broken or worn belt and
replace it with a new belt. Replace the
brush cover, aligning the two U-shaped
slots in the brush cove r with the center
screw housings.
6.Replace the upper housing by
hooking the projection on the front
side of the upper housing to the
lower housing and securing it with
the two screws.
Screws
Tornillos
1.Desenchufe la aspiradora y afloje
los dos tornillos de la caja inferior
del cabezal electrico.
2. Retire la caja superior del cabezal
electrico.
Upper housing
Caja superior
3.Quite el forro del pincel.
4. Separe y retire el cepillo vibrante.
5. Sustituya la correa rota o danada
por una nueva. Equipe el forro del
pincel, alineando las dos ranuras
U-shaped slots
con forma de U con los tornillos
Ranuras en U
centrales del housing.
Brush cover
Tapa del cepillo
Screws
Tornillos
6.Sustituya el housing superior de la
parte delantera colgandolo
mediante dos tornillos.
10
Hole
Orificio
~
Publicidad
Tabla de contenido
