Assembly Procedure - Skoda DMM 630 001 Manual De Montaje

TRUNK GRILLE
The accessories are intended for professional fitting. Škoda Auto recommends the fitting to
be carried out by its contract partners.
Attention. The trunk grille shall not be used in vehicles fitted with a separate heating
(due to collision of the trunk grille fixture and the separate heating remote control unit).

Assembly procedure

Remove the trunk cover from the vehicle and tilt the backrests of the back seats.
Mount the trunk grille as shown on the pictures in the manual. Perform the individual
operations of the trunk grille fitting on both sides of the car in the same way.
During the drilling operation make sure the metal chips are sucked up properly to avoid
damaging the car interior.
Note. If the riveting nuts get lost, they can be ordered from the original Škoda spare
parts catalogue under Part No. 5L6 071 754.
List of special tooling
A preparation to rivet the riveting nuts (B) (into the holes in the body panel under the trunk
carpeting and into the holes in the roof side bearer under the roof panel):
- MTX 9-193/A, spanner OK 13, wrench no. 10
Preparation for drilling holes to the ceiling panel between the C-pillar and the D-pillar of the
vehicle:
- MTX 9-193/B
Preparation for screwing on spacers (D) and (E):
- Screw M8 x 50, self-locking nut M8.
Upholstery pins, pencil, tape measure
Explanation of the figures
The fastening point for mounting the trunk grille in the side trunk carpeting (Fig. 2 - 5)
- Place for drilling a hole into the trunk carpeting is marked with a small point from the manu-
facture.
- Drill holes of 22 mm diameter only into the side lining of the luggage compartment.
- Rivet the riveting nuts (B) using the preparation MTX 9-193/A into the holes of the lid
panel under the lining of the luggage compartment as follows:
- fit the riveting nut (B) on the riveting preparation,
- insert the preparation with the fitted riveting nut into the opening in the carriage body,
- by gradual tightening of the nut on the screw rivet the riveting nut,
- keep tightening the nut on the screw until it stops, otherwise the riveting nut will be lose,
- release the nut and uncsrew the preparation.
- Screw the spacers (E) on using the screw M8 x 50 and the self-locking nut M8 as
follows:
- screw the spacer on the screw,
- tigthen the self-locking nut to the spacer,
GB