HARDWARE CONTENTS
AA
BB
Wire
Short
Connector
Machine
Qty: 3
Screw
Qty: 2
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNING
•
IMPORTANT: NEVER attempt any work without shutting off the electricity.
•
Place the main power switch in the "OFF" position and unscrew the fuse(s), or switch "OFF" the
circuit breaker switch(es), that control the power to the fixture or room you are working in.
•
Place the wall switch in the "OFF" position. If the fixture to be replaced has a switch or pull chain,
place it in the "OFF" position.
•
Do not use bulbs with wattage greater than specified on this fixture.
•
California Proposition 65
WARNING: This product can expose you to lead, which is known to the State of
California to cause cancer, birth defects or other reproductive harm. For more
information go to www.p65warnings.ca.gov
CAUTION
• If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate
completely, please contact a licensed electrical contractor.
• All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts
out, or use any parts that are worn out or broken. Failure to obey this instruction could invalidate
ETL listing and/or C.S.A. certification of this fixture.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated assembly time: 30 minutes to 1 hour
Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, wire strippers,
electrical tape, ladder, safety glasses.
CC
DD
Threaded
Knob
Washer
Qty: 2
Long
Machine
Screw
Qty: 2
EE
Lock
Qty: 2
3