Kohler Vanity K-2451 Guia De Instalacion página 4

2x6
Backing
Material
1. Wall Preparation
Measure and mark 36-1/4" (92.1 cm) up from the floor. This will
be the height from the top of the 2x6 backing material to the
floor.
Secure the 2x6 backing material to the studs with framing nails.
Install the water supply and drain lines according to the
roughing-in information provided with your lavatory. The water
supply nipples must extend at least 3" (7.6 cm) beyond the
finished wall material.
Complete the finished wall. Make sure the finished wall is
straight and plumb, and the floor is flat and perpendicular to the
finished wall.
IMPORTANT! Do not install any moldings that may inhibit the
vanity from being plumb against the finished wall.
1049900-2-B
36-1/4" (92.1 cm)
4 Kohler Co.