Installation Of The Mount On A Loadbearing Wall, Not Aerated Concrete (Plaster Thickness No More Than 40 Mm) - ONKRON NP25 black Guia Del Usuario

2.2 Installation of the mount on a loadbearing wall, not
aerated concrete (plaster thickness no more than 40 mm)
• Put the drilling template (L) to the wall, mark drilling spots.
L
• Drill holes using a Ø 10 mm (3/8") bit at
depth minimum 3.54" (90mm).
Put the mount to the wall the way,
that mounting slots are located at
the bottom.
• Insert dowels (I) into the holes. Make sure that dowels are
completely in the wall. Tap them with a hammer.
• Install the mount on the wall using screws М7х80 (Н).
IMPORTANT: Do not use the wrench (G) from the kit!
6
I
H
90 mm
(3.54")
The bottom
of the bracket
G