Hella HydroLUX 1000 FF Instructions De Montage página 11

Electrical connection
See page 3 for
illustration
Headlamp
adjustment
11
Use the Hella wiring harness
developed especially for this
purpose, or connect the
headlamps as follows: Install
the appropriate Hella relay
(available from accessory
dealers) with the connection
terminals pointing downwards,
so that it is protected against
splash water.
To achieve optimum
illumination of the road, the
headlamps must be adjusted
precisely by a garage. After
successful adjustment of the
headlamps, the headlamp base
One more tip:
• Always keep the headlamp
lenses clean. Dirt can absorb
up to 80% of the light output.
You drive more safely when
you can see well and can
therefore also be seen well.
Do you have spare bulbs and
fuses in your vehicle?
Use Circuit Diagram
to connect the auxiliary
headlamps so that they are
switched together with the
existing driving lamps.
must be screwed tightly to the
housing.
• If you have any questions or
installation problems: Contact
the Hella Service Department,
Telephone.
• Outside normal office hours
an answering machine is
available for recording your
questions or requests.
The Hella Service Department
Use Circuit Diagram
to connect the auxiliary
headlamps so that they are
switched on in addition the
existing driving lamps via a
separate switch. Install the
appropriate switch on the
dashboard.
will then call you back. Ask
your dealer for the complete
Hella calalogue or write to:
Hella KGaA Hueck & Co.
59552 Lippstadt