Wall Mount Installation; Final Assembly - KlipXtreme KTM-876 Guia Del Usuario

Standard flat panel mount installation
CAUTION: Verify the adequate thread engagement of the screw/spacer combination
on your TV to avoid damaging the unit.
9. If your TV has a curved back or recessed mounting points, spacers and longer
screws must be placed between the mounting plate and the screen to compensate
the difference in depth.
Screen with a curved back or recessed mounting points
10. Tighten the plate to the screen using a screwdriver. Be careful not to over-tighten
the screws to avoid damaging your device.

4. Wall mount installation

1. For gypsum or wooden walls, first locate studs in the wall. You may use a stud finder to
determine the center of each stud.
2. Using the wall plate as a template, mark the four mounting positions on the wall. Make sure
the mounting holes are aligned vertically and centered on the stud.
3. Check the bubble level. If the bubble is centered between the lines, it means that the wall
plate is correctly positioned on the surface.
4
4. Drill pilot holes using a drill bit, as specified in the drawing. For concrete or brick walls, insert
the anchors making sure they are seated flush with the surface.
5. Insert bolts and drive them in partially, allowing them to protrude by 3mm from the wall.
6. Bolts must be tightened up later, during the final assembly of the mount.
4a
4b
7. Finish by installing the decorative covers on the top and bottom of the plate.
4c

5. Final assembly

Note: Some flat panels require two people to lift and position it onto the extension arm.
5