Choke Lever (If Present); Primer Control Button; Using The Machine; Preliminary Procedures - ST BC 25 H Manual De Instrucciones

5.5 CHOKE LEVER (IF PRESENT)

Used to turn on the engine when cold. The
choke control has two positions (Fig. 12.E):
Position A - the choke is not engaged
(normal operations and warm start).
Position B - the choke is
engaged (for a cold start).

5.6 PRIMER CONTROL BUTTON

Press the rubber button of the
primer to inject fuel into the
carburettor to facilitate startup when
the engine is cold (Fig. 12.F).

6. USING THE MACHINE

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
IMPORTANT The machine
is supplied without fuel.

6.1 PRELIMINARY PROCEDURES

Before using the machine:
1. place the machine in a stable
horizontal position on the ground;
2. choose the most suitable cutting means
for the job to be done (par. 4.3);
3. perform refuelling. For fuel filling methods and
precautions (see par. 7.2 and paragraph 7.3);
4. wear the harness correctly
(see paragraph 6.1.1).

6.1.1 Using the harness

The harness and straps must be adjusted
to suit the operator's height and stature.
Always use a harness that is suited
to the weight of the machine:
– for machines weighing less than 7.5 kg,
single or double belt models can be used;
– only the double belt model must be used
for machines weighing more than 7.5 kg.
• Models with single belt
The harness must be put on before connecting
the machine to the special coupling.
The belt (Fig. 13.A) must go from the
left shoulder to the right hip.
The belt must be worn with:
– the support (Fig. 13.A.1), the machine
coupling clip (Fig. 13.A.2). and
the quick release clip (Fig. 13.A.3)
positioned on the right side.
• Models with double belt
The harness must be put on before connecting
the machine to the special coupling.
The belt (Fig. 13.B) must be worn with:
– the support (Fig. 13.B.1), the machine
coupling clip (Fig. 13.B.2). and
the quick release clip (Fig. 13.B.3)
positioned on the right side.
– the quick release clip on the
front (Fig. 13.B.3);
– the belts cross-over on the
operator's back (Fig. 13.B.4);
– the buckles correctly fitted (Fig. 13.B.5).
The belts must be tensioned so that the load
is evenly distributed on the shoulders.

6.2 SAFETY CHECKS

Run the following safety checks and
check that the results correspond to
those outlined on the tables.
Always carry out the
safety checks before use.

6.2.1 General check

Object
Hand grips (Fig. 1.F,
Fig. 1.G, Fig. 1.I)
Cutting means
guard. (Fig. 1.E)
Connection point of
the harness (Fig. 1.J)
Quick release clip
(Fig. 13.A.3, Fig. 13.B.3)
Screws on the machine
and on the cutting means
EN - 9
Result
Clean, dry and fixed
firmly to the machine.
Suitable for the cutting
means used, fixed
correctly and firmly to
the machine, not worn/
deteriorated or damaged.
Correctly positioned.
Efficient. Must enable
the machine to be
freed rapidly in the
event of danger.
Correctly tightened
(not loose)