To Adjust The Angle Of The Product; To Use The Save Function; To Adjust The Length Of The Shaft; Automatic Shutdown Function - Husqvarna 520iHT4 Manual Del Usuario

To adjust the angle of the product

The cutting attachment can be adjusted in 8 different
positions.
1. Remove the battery from the product.
2. Pull down the position adjustment handle.
3. Tilt the cutting attachment with the handle to the
applicable position.
4. Release the position adjustment handle to lock the
cutting attachment.

To adjust the length of the shaft

1. Release the knob.
2. Pull out the shaft to the applicable length.
1266 - 001 - 04.12.2019
3. Tighten the knob.

To use the SavE function

This product has a power saving function, SavE. The
SavE function decreases the speed of the cutting
equipment and gives the longest operation time from the
battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Push the SavE button on the keypad to start the
function. The green LED comes on.
2. Push the SavE button again to stop the function. The
green LED goes out.

Automatic shutdown function

The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
45 seconds.

To set the product in transport position

WARNING: Do not start the product when
the product is in transport position.
1. Remove the battery from the product.
2. Install the transport guard on the cutting attachment.
3. Fold the cutting attachment 180° to make the cutting
attachment parallel to the shaft.
13