Summer Sure & Secure 12434 Manual De Instrucciones página 2

COMPONENTS:
Frame
Corners
(2 Pieces)
Non-Folding
Frame Corners
(2 Pieces)
FRAME CORNER CONNECTOR SET UP:
A1
FULL SIZE CLIP
Frame Corner Connector Sizing
Step 1:
Attach the Bed Size Clips to the Frame Corner Connector.
You will feel it lock into place.
(Figure 1)
NOTE: If you are using a Queen size bed, you will not
have to attach the Bed Size Clips, the strap at full length
is already sized for a Queen size bed.
Step 2:
Lift mattress, one end at a time, and slide the
Frame Corner Connector assembly underneath,
between the mattress and boxspring.
(Figure 2)
NOTE: Place the wings on the Frame Corner Connectors
flush against the boxspring. Make sure that the connecting
strap is not twisted so that the strap is flat against the
boxspring. The Frame Corner Connector (A1) will need
to be on the side where the Bedrail will be located.
Step 3:
The Frame Corner Connector has been set to the tightest
fit possible by the manufacturer. If your mattress is oversized
or too wide to fit within the manufacturers setting then adjust
the Frame Corner Connector to fit the mattress. In order to
make sure you maintain the tightest fit possible, push the pins
on the side inwards towards the center and pull the corner
of the Frame Corner Connector outwards one slot.
If the fit is still too tight, repeat the last step until
the Frame Corner Connector fits the mattress.
(Figure 3)
Lower Folding Frame
with Fabric
(1 Piece)
Lower Non-Folding Frame
with Fabric
(1 Piece)
QUEEN SIZE
TWIN SIZE CLIP
Frame Corner
Connectors
(2 Pieces)
A2
1
2
3
A2
(CLICK)
A1
BOXSPRING
(CLICK)
A1
2x
2x
2x