Safety Cut-Out; Cleaning And Maintenance - Kalorik JK 46670 SS Manual Del Usuario

CAUTION: Make sure that the lid is closed, and the filter is correctly and
securely fitted before switching on the appliance. Failure to do so will
cause the kettle not to switch off.
• Do not leave water in the kettle after use as this quickens the
formation of scale.
• For instant re-boiling, wait until water has cooled down and switch
on the appliance again.
• The kettle will not re-boil until the switch is pressed again.
• The kettle may be stored on the power base when not in use.
• Always disconnect the power supply when not in use.
• When pouring a large quantity of hot water, pour slowly and do not
incline the kettle past the horizontal line to avoid burns and injuries.

SAFETY CUT-OUT

This cordless water kettle is protected with an automatic safety
•
device, if accidentally switched on without water. Please bear in
mind that only the thermostat is switched off in case of overheat,
whereas the switch stays in the ON-position.
If this happens, switch off the appliance by putting the switch in the
•
OFF position and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element. This will
reset the safety device.
The kettle may then be used as normal.
•

CLEANING AND MAINTENANCE

Before attempting any cleaning operation, make sure the
•
appliance is unplugged from the supply socket and fully cooled
down.
To clean the exterior surfaces, simply wipe over with a soft, damp
•
cloth and dry thoroughly.
Never use abrasive products, powders or scouring pads.
•
Under no circumstances shall the jug kettle or its power base be
•
immersed in water.
To remove mineral deposits from the water kettle, use products
•
(decalcifying solutions) made especially available for this purpose.
Make sure to use a type recommended for kettles or coffee makers.
www.KALORIK.com
8
JK 46670 SS – 200420