Tools Required - Whittier Wood Furniture 558W Instrucciones De Montaje

Phillips Head Screwdriver, Rubber Mallet or Padded Hammer, Wood Glue, Tape Measure
F
1. Place the Bottom Shelf (F) on a clean, protected surface so the pocket holes face up. Spread a thin
layer of glue in the dowel holes on the Bottom Shelf and insert the Left Vertical Divider (E) and Right
Vertical Divider (D) so that the square notches face the back as shown in Figure 1. Tap with a rubber
mallet and quickly wipe away any excess glue with a damp rag. Using the pocket holes as guides,
attach with four 4x32mm Pan Head Screws (M). See Figure 1.
2. Spread a thin layer of glue in the upper two dowel holes on the Left Side (C) and insert the Bottom
Shelf Assembly. Tap with a rubber mallet and quickly wipe away any excess glue. Using the pocket holes
as guides, attach the Left Side (C) to the Bottom Shelf Assembly with two 4x32mm Pan Head Screws
(M), making sure the square notches on the Left and Right Dividers face the back and the curved
notch on the Left Side faces the front. See Figure 2.
558W Westport Storage Shelf
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED:

IMPORTANT NOTES:
We recommend finishing this unit prior to assembly.
Before doing so, completely read the enclosed Finishing Hints.
E
M
Fig. 1
C
M
Fig. 2
D
M
View from the Front
M
x 4
M
x 2
558W — 01/09 — Page 3