Safety Devices; Safety Instructions - HOLZMANN MASCHINEN HOB 260ABS Instrucciones De Servicio

14.3 Safety Devices

The machine is equipped with the following safety devices:
Blade guard
(blade shaft cover)
Separating protective
device behind planer
fence
Belt and chain cover

14.4 Safety instructions

To avoid malfunctions, damage and health hazards when working with the machine, the following
points must be observed in addition to the general rules for safe working:
 Before commissioning, check the machine for completeness and function. Only use the
machine if the guards and other non-separating guards required for machining are fitted,
are in good operating condition and have been properly maintained.
 Choose a level, vibration-free, non-slip surface for the installation location.
 Ensure sufficient space around the machine!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects!
 Ensure a clean working environment!
 Only use suitable tools that are free of cracks and other defects (e.g. deformations).
 Remove setting tools from the machine before switching it on.
 Keep the area around the machine free of obstacles (e.g. dust, chips, etc.).
 Check that the machine is in perfect condition before each use.
 Never leave the running machine unattended.
 The machine may only be operated, maintained or repaired by persons who are familiar
with it and who have been informed of the dangers arising in the course of this work.
 Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
HOLZMANN MASCHINEN GmbH
 An E
MERGENCY
any time.
 Thermal circuit breaker (2) against overheating of the motor
(for 230V). If the motor is overloaded or there is a power
failure, the motor switches off automatically. The machine
cannot be switched on again until the motor has cooled down or
the power supply has been restored.
 Separating protective device:
Prevents contact with the rotating cutter spindle when planing
workpieces.
 Separating protective device (fixed):
To be remove before changing to thicknesser mode
 Separating protective device (fixed):
This protective device must be removed before maintenance
work.
 Safety key on the dust hood: keys must be pressed in
completely (a clear click sound must be heard) to allow the
machine to start.
 Safety lever on the underside of the surface planing table
(engages when the table is folded up).
www.holzmann-maschinen.at
S button (1) to stop dangerous movements at
TOP
SAFETY
37
HOB 260ABS