Complete The Installation - Kohler K-710 Guia De Instalacion

5. Complete the Installation

For Drop-In Installations
Cover the framing with water-resistant wall material. Seal the joints between the bath rim edges and
the water-resistant wall material with silicone sealant.
Tape and mud the water-resistant wall material.
Install the finished wall. Seal the joints between the bath rim and the finished wall with silicone
sealant.
For All Installations
When cleaning up after installation, do not use abrasive cleaners, as they may scratch and dull the bath
surface. Use warm water and a liquid, non-abrasive detergent to clean the surface.
CAUTION: Do not allow cleaners containing petroleum distillates to remain in contact with the surface
for long periods of time.
Remove stubborn stains, paint, or tar with turpentine or paint thinner.
Remove plaster by scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools.
You can use a powder-type detergent on a damp cloth to provide mild abrasive action to any residual
plaster.
1007291-2-B 6 Kohler Co.