Cleaning The Brush Attachment; Cleaning The Appliance; Storage - Silvercrest SAST 18 A1 Instrucciones De Uso

Cleaning the brush attachment

To achieve the best results, the motorised brush attachment
regularly for blockages and any hairs, threads or dirt should be removed.
To simplify cleaning, the brush on the brush attachment
1) If you have not already done so, pull the brush attachment
suction opening.
2) Push the release switch on the brush attachment
arrow (as far as the stop). The brush can now be removed and cleaned. The
release switch automatically springs back into place.
3) To replace the brush after cleaning, proceed as follows:
–
Start by pushing one end of the brush onto the drive shaft on the oppo-
site side of the release switch. Note that only one side of the brush fits
onto the drive shaft.
–
Push the release switch on the brush attachment
arrow (as far as the stop) and hold it there. Now push the other end of
the brush into the appropriate recess on the side of the release switch.
–
Let go of the release switch to lock the brush in place. The brush should
now be straight and firmly attached to the brush attachment

Cleaning the appliance

1) Clean the housing and the attachments with a slightly damp cloth.
For stubborn soiling use a mild detergent on the cloth.
2) Dry all parts thoroughly before using the appliance again or storing it.

Storage

Store the appliance in a dust-free and dry location.
■ 32 │ GB │ IE
should be checked
can be removed:
out of the
in the direction of the
in the direction of the
.
SAST 18 A1