Vimar ELVOX TAB 7529 Instrucciones Usuario página 9

Configurations
Choice of ringtones
10 different ringtones can be selected.
Different ringtones can also be set for out­
door, intercommunicating and door calls
(see below). The ringtones must be selected
with the monitor on stand­by and the hand­
set on the hook.
The button for entering configuration mode
is button A (self­start).
Button E1 selects
ENTRANCE PANEL CALL.
E2
Button selects
INTERCOMMUNICATING CALL.
Button E3 selects the ringtone for DOOR
CALL (exclusively using the button interface
module 6120 or Vimar landing call button). In
the case of a door call by means of a button
connected directly to the monitor's terminals
FP and M, the ringtone cannot be changed.
Configuration:
1) Press button A (self­start) and hold
down (for 2 s) until the LED C (lock)
begins flashing and the monitor emits an
audible signal.
2) Press and hold down the button for the
chosen ringtone (button E1/button E2/
button E3) until the ringtone is heard on
the monitor.
3) Press the button repeatedly (button E1/
button E2/button E3) to select the desi­
red type of ringtone.
4) After choosing the desired ringtone,
press button A or refrain from touching
any buttons for 5s to save. After comple­
ting the configuration, the LED flashes
and then turns off.
EN
the ringtone for
the ringtone for
Ringtone volume adjustment
The ringtone volume can be set to 6 levels
plus mute.
Press button A (self­start) to enter configu­
ration mode.
Press button B (bell) to lower the ringtone
volume.
Press button C (key) to increase the ringtone
volume.
The ringtone volume must be adjusted with
the monitor on stand­by and the handset
on the hook.
Configuration:
1) Press button A and hold down (for 2 s)
until the LED C (lock) begins flashing
and the monitor emits an audible signal.
3) Press button B to lower or button C to
increase the volume. Each time the but­
tons are pressed the volume changes
by one level.
4) After choosing the desired volume,
press button A or refrain from touching
any buttons for 5s to save. After comple­
ting the configuration, the flashing LED
goes off and a "beep" is emitted.
Muting the ringtone (User Away function)
Using the volume adjustment procedure
described above, pressing button B a suffi­
cient number of times results in the ringtone
being muted. The "Ringtone muted" status
is indicated by the button B LED (ringtone
muted) lighting up steadily.
If the monitor receives a call from the entran­
ce panel while the ringtone is muted, this is
indicated by the LED/button B emitting one
flash for each unanswered call up to a maxi­
mum of 4 calls (these flashes occur every
10 s). When the ringtone volume is restored,
at least to its minimum level, this indication
will be reset.
9