EMKO ESM-3721HT Manual De Instrucciones página 10

Repeat cycle of Humidifier ( Default = 00:00 )
This parameter value can be adjusted form 00:00 to 24:00 hour/minute.
Note : if Lou parameter value is 2 or 3, Temperature Alarm parameters are observed.
Temperature Alarm Function Selection Parameter
Temperature Alarm Set Parameter
This parameter value can be programmed between temperature minimum alarm set
parameter and temperature alarm set maximum
Temperature Alarm
This parameter value can be adjusted form 0.1 to %50 of the device scale if Pnt parameter
is 1, 1 to %50 of the device scale if Pnt parameter is 0.
Alarm Set Minimum Parameter (Default = Minimum Value of Device Scale)
if temperature alarm is active, this parameter value can be adjusted from minimum value of
device scale to temperature alarm set maximum parameter value.
Alarm Set Maximum Parameter ( Default = Maximum Value of Device Scale)
if temperature alarm is active, this parameter value can be adjusted from temperature
alarm set value parameter
Temperature Alarm On Delay Time Parameter
Temperature Alarm On Delay Time can be defined with this parameter. It can be
adjusted from 0 to 99 minutes.
Temperature Alarm Delay After Power On Parameter
When power is first applied to the device, this time delay must be expired for activation of
temperature alarm.
Buzzer Function Selection Parameter
Buzzer Active Time
If buzzer function selection parameter
Buzzer active time can be define with this parameter. It can be adjusted from 1 to 99
minutes. When this parameter is 1, if decrement button is pressed,
this condition buzzer is active till buzzer silence button is pressed.
Button Protection Parameter
Programming Mode Accessing Password
It is used for accessing to programming mode. It can be adjusted from 0 to 9999. If it is 0,
password is not entered for accessing to the parameters. If password is '12' only
Can be accesible.
Process High alarm selected.
Process Low alarm selected.
Deviation Band alarm selected.
Deviation Range alarm selected.
Hysteresis
It can be adjusted from 0 to 99 minutes.
Buzzer is inactive.
Buzzer is active during temperature alarm
Buzzer is active during Temperature sensor failures.
Buzzer is active during Temperature sensor failures or temperature alarm.
( Default =
There is no protection.
Temperature set value can not be changed.
Manual engine start is not available.
Temperature set value can not be change and Manual engine start is not
available.
( Default = 50.0 °C )
Parameter ( Default = 0.1)
to maximum value of the device scale.
( Default = 0)
( Default = 0 )
)
value = 0, this parameter is not observed.
( Default = 0 )
( Default = 0 )
( Default = 0 )
parameter.
( Default = 0)
is observed. In
,
10