Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.3 Panel Mounting and Removing
3
1-Before mounting the device in your panel, make
sure that the cut-out is of the right size.
2-Insert the device through the cut-out. If the
mounting clamps are on the unit, put out them
before inserting the unit to the panel.
3- Insert the mounting clamps to the fixing sockets
that located left and right sides of device and
make the unit completely immobile within the
panel
3. Electrical Wiring Diagram
Relay Outputs
c
To reduce the effect of electrical noise on device, Low voltage line (especially sensor input
cable) wiring must be separetely from high current and voltage line.
If possible, use shielded cable and shield must be connected to ground only one side.
3
2
P/N : ESM-3721
2x3A@ 250V V
2x3A@ 250V V
230 VV ± 15%
230 VV ± 15%
5A @250VV
5A @250VV
50/60Hz - 1.5VA
50/60Hz - 1.5VA
a
a
3
3
5
5
6
6
7
7
8
8
1
1
2
2
4
4
1
2
3
4
5
6
7
8
a
N
L
Power Supply Input Temparature Sensor Input
V ±
230V
( %15) 50/60Hz ,
V ±
115V
( %15) 50/60Hz ,
V ±
24V
( %15) 50/60Hz ,
W ±
24V
( %15) 50/60Hz ,
Z
1.5 W
10...30 V
Must be determined in order.
3
1-Pull mounting clamps from left and right
fixing sockets.
2-Pull the unit through the front side of the
panel
c
Before starting to remove the unit
from panel, power off the unit and
the related system.
9 10
9 10
11 12
11 12
9
10
11
12
( PT-100)
1
2
5
Publicidad
Tabla de contenido
