EMKO ESM-3721HT Manual De Instrucciones página 8

5. Changing and Saving Temperature Set Value
Main Operating Screen
When SET button pressed ''S'' led will
be active and temperature set value will
be displayed.
SET Value Screen
When SET button pressed
temperature set value can be saved.
Temperature set value parameter ( Default = 37.7
Temperature set value, can be programmed between minimum temperature set value
maximum temperature set value
If no operation is performed in temperature set value changing mode for 5 seconds, device
i
turns to main operation screen automatically.
5.1 Programming Mode Parameter List
Temperature Unit Selection Parameter ( Default = 0 )
Decimal Seperator Enabling Parameter
Note : When value of C-F or Pnt parameters are changed , the values of Set ,hSt, Suh,
SUL ,oFt, Ast, ALh,AUL and Auh parameters should be changed accordingly.
Temperature Control Selection Parameter On/Off or PID ( Default = 0 )
Note: If this parameter is select 0, PID parameters will be not observed.If this parameter
select 1,
Self Tune
PAUSE
ü ü
ü
PAUSE
ü ü
ü
.
°C selected.
°F selected.
None.
Only Temperature parameters with decimal seperator.
On - Off selected.
PID selected.
parameter will be not observed.
Selection Parameter ( Default = 0 )
Device does not do operation.
Device does operation.
SET Value Screen
Temperature set value can
be changed with increment
and decrement buttons.
Main Operating Screen
''S'' will be inactive and goes
back to main operation screen.
°C )
( Default = 1 )
PAUSE
ü ü
ü
PAUSE
ü ü
ü
and
8