Disposing Of The Batteries - Bissell CROSSWAVE CORDLESS MAX 2590 Serie Manual Del Usuario

Disposing of the Battery
Go to BISSELL.com/support for resources on battery disposal.
Before disposing the battery, make sure:
• The machine is disconnected from the 3-in-1 Docking Station.
• The Clean and Dirty Water Tanks are empty or removed from the machine.
• A Phillips-head screwdriver, electrical tape and rubber handled wire cutters are available for
disassembly.
1.
With a Phillips-head
screwdriver, remove the 4
screws on the back of the
machine. Lift off the back
cover.
4.
Remove the 4 screws from
the battery pack and lift off
the top cover to expose the
control panel and battery cells.
NOTICE
Disconnecting the battery will destroy the appliance and invalidate the warranty.
WARNING
and State regulations, removal and proper disposal of lithium-ion batteries is required. For removal of the
batteries in your appliance, see instructions on this page. For specific disposal instructions of batteries, please
contact the RBRC (Rechargeable Battery Recycling Corporation) at 1-800-822-8837 or visit www.Call2Recycle.org.
10 BISSELL.com
2.
Cut the red positive
(+) battery wire with wire
cutters. Wrap the end of the
cut wire with electrical tape.
Individually cut the remaining
battery wires.
5.
Remove the last two screws
on the control panel.
This product contains lithium-ion rechargeable batteries. According to Federal
3.
Using a Phillips-head
screwdriver, remove the 4
screws located on the sides of
the battery pack and remove it
from the back cover.
6.
Pull the control panel back
from the battery pack. With
wire cutters, clip all the metal
poles to disconnect the battery
pack from the control panel.
Keep battery pack together
– DO NOT separate individual
batteries.