Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Removing Packaging
NOTICE
To prevent damage to your floor keep the unit in its
packaging base until ready to be placed in the cabinet
opening. Do not slide the unit across the flooring.
Different models use different packaging materials.
Actual brackets may look differently. Bracket remains in
packaging base.
1.
Cut straps on outside of box.
2.
Remove cardboard box.
3.
Remove all top and side cardboard and Styrofoam
braces.
4.
Place oven in front of cabinets where it is to be
installed.
Connection to the home network (LAN)
This appliance is network-compatible and can be
connected to the home network using a LAN cable (LAN
cable not included). Before installation, plug the LAN
cable into the socket on the rear of the appliance and
secure it using the strain relief. Connect the LAN cable
to a network socket.
Water connection
The appliance is backflow-proof (VDE tested).
Connection valves with backflow preventers are not
required. Follow the regulations of the local water utility.
Install a suitable descaling system in front of the
appliance if the water hardness exceeds 7 dH.
Only connect the appliance to a cold-water
connection:
Connection ¾" (26.4 mm)
▯
Water pressure 2-10 bar
▯
min. 2.6 gal (10 liters)/minute
▯
Note: The water connection for the supply hose must
always be accessible (not directly behind the appliance).
Waste water connection
Provide for an odor trap on the drain connection. The
connection on the odor trap must always be accessible
(not directly behind the appliance).
Important notes on the drain hose
Do not fit the drain hose at any point higher than the
▯
bottom edge of the appliance
Drain: at least ø1½" (38 mm) inner diameter
▯
Drain connection: at least 4" (100 mm) lower than the
▯
appliance drain
Do not kink the drain hose
▯
Do not shorten the included drain hose
▯
Drain hose: no more than 5.5 yards (5 m) long
▯
Preparing Kitchen Units
en-us
9
Publicidad
Capítulos
Tabla de contenido
