Assembly - Attaching The Fan Blades; Attaching The Blades To The Blade Brackets - HAMPTON BAY 59299 Guía De Uso Y Mantenimiento

Ventilador de techo palm beach ii, de 48” (1,22 m)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Attaching the Fan Blades

8
Attaching the blades to the blade
brackets
Attach a blade (H) to a blade bracket (G) by inserting screws
(AA) into the holes in the blade and through the blade
bracket. Note that the rubber washers are preattached to
the blade bracket.
Tighten each screw securely.
Repeat these steps for each blade (H) and blade bracket (G).
H
G
9
Fastening the blade assemblies to
the motor
Fasten the blade assembly to the fan-motor housing (D) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the blade bracket screws (TT). The blade
AA
bracket screws (TT) are pre-installed into the blade bracket (G).
Repeat this step for the remaining blade assemblies.
TT
10
IMPORTANT: Remove the rubber stopper on the black bracket
below the motor in order to attach the blade assembly to
the motor. Replace the rubber stopper to prevent water from
entering the switch housing and to reduce the risk of fire,
electric shock, or other personal injury.
D
G

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

5969948-pbh191-410252-121

Tabla de contenido