Black 1-9/16" Flat Head Screw - Sauder 158082 Manual Del Usuario

Step 13 Step
1
D83
Groove
å
Insert the DRAWER SIDES (D83 and D84) at an angle
into the slot at each end of the DRAWER FRONT (K2).
3
M64
Surface with
HIDDEN CAM
å
Fasten the DRAWER BRACE (M64) to the
DRAWER FRONT (K2). Tighten one HIDDEN CAM.
Page 18
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
K2
D84
Maximum
Arrow
210 degrees
Minimum
190 degrees
K2
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
i s h
r f a
c e
D83
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D977) into the
grooves in the DRAWER SIDES (D83 and D84) and
DRAWER FRONT (K2).
4
D83
M64
å
Fasten the DRAWER BACK (D169) to the DRAWER
SIDES (D83 and D84) and DRAWER BRACE (M64). Use
five BLACK 1-9/16" FLAT HEAD SCREWS. (30S).
158082
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
e d
D977
K2
D84
Start each screw a few turns before
completely tightening any of them.
30S

BLACK 1-9/16" FLAT HEAD SCREW

(5 used in this step)
D169
Be sure the
DRAWER
BOTTOM
D84
inserts into
the DRAWER
BACK groove.
www.sauder.com/services