Thrustmaster TS-XW RACER sparco P310 Manual De Usuario página 9

ATTACHING THE RACING WHEEL
Attaching the racing wheel's base to a cockpit
1. Place the racing wheel's base on the cockpit shelf.
2. Drive two M6 screws (not included) through the cockpit shelf, then feed them into the two small
screw threads located on the underside of the racing wheel.
Important: The length of the two M6 screws must not exceed the thickness of the shelf + 12 mm;
longer screws could cause damage to internal components located in the racing wheel's base.
3. If required, tighten the standard attachment system by inserting the fastening screw in the large
threaded hole.
Attaching the racing wheel to a table or a desktop
1. Place the racing wheel on a table or any other horizontal, flat and stable surface.
2. Insert the fastening screw (9) in the attachment system (8), then tighten the device by turning the
screw anticlockwise, so that it feeds into the large threaded hole (7) located beneath the racing
wheel, until the wheel is perfectly stable.
ALWAYS
WARNING:
- Never tighten the screw alone, without the attachment system in place (this could
damage the racing wheel).
NEVER
8/22