Hour Meter
The Hour Meter tracks hours of operation for
scheduled maintenance. See Figure 2-3.
NOTE: The hour glass icon will flash when the
engine is running. This signifies the meter is
recording hours of operation
Figure 2-3. Hour Meter
Connection Plugs
120 VAC, 20 Amp, Duplex
Receptacle
The 120 Volt outlet is overload protected by a 20
Amp push-to-reset circuit breaker. See Figure 2-4.
Each receptacle will power 120 Volt AC, single
phase, 60 Hz electrical loads requiring up to 2400
watts (2.4 kW) or 20 Amps of current. Use only high
quality, wellinsulated, 3-wire grounded cord sets
rated for 125 Volts at 20 Amps (or greater).
Figure 2-4. 120 VAC, 20 Amp, Duplex
Receptacle NEMA 5-20R
6
0.0
120 VAC, 30 Amp Receptacle
Use a NEMA L5-30 plug with this receptacle (rotate
to lock/unlock). Connect a suitable 3- wire cord set
to the plug and to desired load. The cord set should
be rated for 125 Volts AC at 30 Amps (or greater).
See Figure 2-5. Use this receptacle to operate 120
Volt AC, 60Hz, single phase loads requiring up to
3000 watts (3.0kW) of power at 25 Amps. The outlet
is protected by a 25 Amp circuit breaker.
Figure 2-5. 120 VAC, 30 Amp Receptacle
Remove Contents from Carton
1. Open carton completely by cutting each corner
from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain the
following:
Owner's Manual for Petrol Generator