Hoover POWERDASH Manual Del Usuario página 9

Getting Started With Your PowerDash
How to Clean Carpets with your PowerDash
1
Plug power cord into
electrical outlet.
2
Step on the Handle
Release Pedal to
recline the unit for
cleaning position.
3
Step on ON/OFF
Pedal to turn ON.
Carpet Cleaner
™
:
™
4
Squeeze trigger for
a slow forward and
backward wet stroke*.
5
Release trigger for
a slow forward and
backward dry stroke* .
For Best Performance
• For full suction, it is important that the Dirty Water Tank is
properly secured before cleaning.
• Continue using dry strokes until little water is visible
passing through the nozzle.
• Hoover recommends rinsing carpet with water only.
This removes residual carpet cleaning solution. Fill
Solution Tank with water and repeat. For heavily soiled
areas, repeat. Avoid saturating carpet.
*follow these steps for best results
CAUTION:
Do not clean over floor electrical
outlets. Water will drip from the brushes and
underside of the product after use and may puddle.
To avoid damage to wood and laminate flooring and to
avoid potential slip hazard, after use (a) do not leave
the product on wood and laminate surfaces and move
to a hard surface and (b) place unit on an absorbent
material (such as a towel) to soak up drips.
NOTE: Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in suction
(see "Automatic shut-off"). You will also see the float
rise and shut off suction at the same time.
9