Remote Control - Chicco Ducati Multiplay Track Manual De Instruciones

1. connect the arch of the bridge to the straight swing-bridge section of the track by slotting the two pins
on the straight section into the two holes on the arch. The Chicco logo must be positioned on the outside
of the straight section of the track (Diag.2.A). Repeat this procedure for the other straight section.
2. once the 2 straight sections have been assembled, position them on the bridge base, slotting the guide
onto the metal pin, as seen in diagram 2.B
ASSEMBLING THE TRACK
Straight track: see diag. 5
Circular track: see diag. 6
Figure of 8 track: see diag. 7
HOW TO USE THE TOY
HOW TO SWITCH ON THE MOTORCYCLES AND REMOTE CONTROLS:
Switch the motorcycles and remote controls ON by moving the ON/OFF switches (diag. 8-A e diag. 8-B)
to I, after inserting the batteries following the instructions provided in the FITTING AND/OR REPLACING
BATTERIES chapter. The motorcycle will automatically switch to stand–by mode to save battery-life if it not
used for 10 minutes. Turn the motorcycle OFF and ON again to play again.

REMOTE CONTROL

The remote control can be used in two different ways: inside the cylinder in the Pits curve (diag. 1A) or held
by the child in his hands.
• Use inside the cylinder: position the remote control inside the cylinder as seen in diagram 3. There is only
one way to insert the remote control inside the cylinder, where the cylinder guide matches the remote con-
trol guide. Once the remote has been fitted inside the cylinder, simply press it downwards to send a signal
that activates the motorcycle for 16 seconds (about 2 laps). The use of the remote control in this mode
allows small children of 12 months old to play with this toy.
This remote control set-up is recommended when using the toy in "straight line" and "ring circuit" modes.
• Use outside the cylinder: press the forward (diag. 4 A) and reverse (diag. 4b) button to command the
motorcycle. This mode is recommended when using the toy in "Figure of 8 shaped circuit" and "off-track"
modes.
STOP & GO BUTTON
A "STOP & GO" button is positioned in the Pits area. When pressed, a stop panel appears which prevents
the motorcycle from continuing along the track. Simply press the button again to allow the motorcycle to
continue (see DIAG. 9)
FITTING AND/OR REPLACING BATTERIES
WARNING!
• Batteries must only be replaced by an adult.
• To replace batteries:
1. Use a screwdriver to loosen the battery compartment cover screw and access the batteries.
The battery compartment on the motorcycles is found at the front near the headlamp, the battery com-
partment on the remote control is found at the side (Diagram 10)
2. Open the battery compartment cover, remove the spent batteries and fit the new batteries making sure
they are fitted with their poles in the right direction (as indicated on the product).
3. Replace the cover and tighten the screw.
• Only use alkaline batteries of the same type or equivalent to the type recommended for the correct fun-
ction of this product.
• Never mix alkaline, standard (zinc-carbon) or rechargeable (nickel-cadmium) batteries.
• Never mix new and old batteries.
• Always keep batteries and tools out of the reach of children.
10