Chapter 6 Preparations Before Operation; Installation Of Recording Paper - Gima ECG 300G Manual De Instrucciones

6.1 Installation of recording paper

6.1.1 The device adopts high-speed recording paper, its specification is 80 mm(W)×20 m(L).
6.1.2 The installation method of recording paper is described as below:
1. As shown in Figure 6-1, open the paper cabinet cover, take out the paper axis, insert it into the
roll paper as shown in the figure. The paper side with grids should be faced downwards, and then
install it to proper position in the paper cabinet.
2. Close the paper cabinet cover, it would be better to leave 2cm paper outside the exit of paper
cabinet.
Note
Ø The recording paper should be aligned with the slot of the paper cabinet cover. It is
recommended to leave 2cm paper outside.
6.1.3 If the recording paper runs out during recording, the device will stop printing automatically,
and the screen will display a prompt of lack of paper, as shown in Figure 6-2.

Chapter 6 Preparations before Operation

Figure 6-1 Installation of recording paper
Figure 6-2 Lack of paper prompt
14