Metro GCV1100 Manual De Instrucciones página 16

Storage
• Before storing, remove all foodstuffs from the
appliance, disconnect it from the supply and clean
the appliance and its accessories thoroughly.
• Store the appliance in a dry, protected
environment at room temperature and out of the
GB
reach of children.
• Keep the appliance's doors open to avoid smell
or mold.
• To protect the appliance from dust, cover it
with a cloth that allows air circulation inside the
appliance.
4. Troubleshooting
WARNING!
• In case of failures or malfunctions, always unplug
the appliance immediately.
• This appliance does not contain any parts that
can be repaired or serviced by the consumer.
Only perform the steps described in this
instruction manual! All further inspection,
maintenance and repair work must be performed
by an authorized service center or a similarly
qualified specialist.
• When any information is shown on the LED
display that is not described in these instructions,
wait until the appliance's temperature is shown on
the LED display again or set the power switch to
O to avoid damage to the appliance.
• Should you require spare parts, always obtain
them from an authorized seller. Do not use
spare parts that are not recommended by the
manufacturer!
Problem Possible cause Solution
Power plug not
connected to
electrical outlet.
Appliance
does not Supply cord is
operate. damaged.
Other electrical
defect to the
appliance.
Connect power
plug tightly with a
suitable electrical
outlet.
Have supply cord
replaced by the
manufacturer, its
service agent or
similarly qualified
persons.
Have appliance
checked by a
specialist.
- 15 -
Problem Possible cause Solution
Thermostat
is not set
correctly.
Appliance is
located near
heat sources.
Appliance is
placed too near
to the wall or to
other objects.
Doors are not
closed properly
or opened and
closed too
often.
Appliance
does not
Seals are
achieve
damaged.
required
temperature.
Appliance
overloaded,
filled with warm/
hot foodstuffs
or filled in a way
that prevents
proper air
circulation.
Appliance
was filled
before it had
reached the set
temperature.
Appliance is
placed too near
to the wall or to
other objects.
Appliance not
in a stable
Appliance is
position.
very noisy.
There are loose
parts in the
appliance.
Shifting
content inside
appliance.
Normal
Condensation
phenomenon
on outside of
in humid
appliance.
environments.
Murmur of
Normal sound of refrigerant
water during
circulating in the system.
operation.
Set temperature
with thermostat
as described in
this manual.
Move appliance
well away from
heat sources.
Keep a minimum
distance of 10cm.
Close the doors.
Keep them closed
for a while.
Have seals
checked by a
specialist.
Remove several
items, remove
warm/hot
foodstuffs or
reorder contents
of appliance
to allow air
circulation. Make
sure that the air
inlet and outlet are
not blocked.
Remove contents
from appliance.
Let appliance
reach the set
temperature, then
refill it.
Keep a minimum
distance of 10cm.
Place the
appliance on
an even and
stable surface.
Adjust the feet, if
necessary.
Have appliance
checked by a
specialist.
Reorder contents
inside the
appliance.
Wipe appliance
with a dry and
soft cloth.