Graham Field LUMEX RJ5500 Instrucciones De Ensamblaje Y Operación página 4

3. Install both rear legs: Match leg number to frame tube number and insert leg into tube as
shown in fig. 7. Secure with E-clip and male knob as shown in figs. 8 and 9.
WARNING: Ensure all four legs are locked in place at the same height, and that E-clips
and male knobs are tight, before proceeding.
Open the Rollator
WARNING: PINCH POINT - Keep
hands free when adjusting or
lowering seat.
1. Position Rollator upright on wheels
as shown in fig. 10.
2. Open Rollator frame; spread front
and rear legs apart.
3. Push down on both side crossbars
so that locking mechanisms lock
legs open.
4. Fold seat down so that it rests on
both seat frame tubes.
WARNING: Ensure both side
crossbar locking mechanisms are
locked in place before proceeding.
Install the Back Bar
1. Depress knobs to release locking
pins and insert both ends of back
bar into frame receptacles as shown
in fig. 11.
2. When back bar is in position,
release knobs to lock pins in place.
WARNING: Ensure both ends
of back bar are locked in place
before proceeding.
RJ5500-INS-LAB-RevA18
fig. 7
locking mechanism
fig. 8
crossbar &
front leg
rear leg
fig. 11
fig. 9
front seat frame tube
seat
fig. 10
4