Operation - Graham Field LUMEX RJ5500 Instrucciones De Ensamblaje Y Operación

Adjust the Handle Height
Info: Consult your healthcare professional to
determine proper handle height adjustment. See
fig. 12 for approximate desired handle height.
1. Loosen and remove hex bolts and female knobs
from handles.
2. Adjust handles to desired height.
3. Insert hex bolt heads in hex indents on insides of
handles while inserting hex bolts through handles
as shown in fig. 13.
4. Install female knobs on ends of hex bolts on outside
of handles.
5. Tighten knobs.
6. Secure both brake cables onto frame with brake
cable clips as shown in fig. 13.
WARNING: Ensure both handles are adjusted
to the same height, handle knobs are tight,
and brake cables are secured in clips before
proceeding.
s NOTICE: Ensure brake cables are OUTSIDE
handles.

OPERATION

WARNING: BEFORE EACH USE, ensure all knobs
are tight, locking pins locked in place, the pouch
is securely attached, and all attaching hardware
is securely tightened.
WARNING: Ensure that hand brakes stop Rollator
and lock in place appropriately when operating or
sitting on the Rollator. If your hand brakes are not operating correctly, please see your
Graham-Field authorized distributor immediately for service.
WARNING: Ensure items placed in the pouch do not protrude from the pouch.
WARNING: Ensure back bar is always in place during use. DO NOT use the back bar to
support user's entire body weight.
Walking With Your Rollator
Stand behind your Rollator with a hand placed securely on each handgrip. Move your Rollator
slowly forward and select a pace that is comfortable for you. Always be sure the rear wheels
are a few inches ahead of your body.
RJ5500-INS-LAB-RevA18
fig. 12
fig. 13
5