Automated Learning Process./Activating Code - Craftmade Colossus COL72 Guia De Instalacion

11. Automated Learning Process./Activating Code.

CAUTION: The wall and/or handheld remote control can be
programmed to multiple receivers or fans. If this is not desired,
turn wall switch off to any other programmable receiver or
fan.
Restore electrical power and then, if using wall control, set
slider switch on wall control to the ON position. Within 60
seconds of turning on the wall control, press and hold the
fan SET button on the wall control for 5 seconds or until
light kit (if installed) blinks twice.
Turn power off again for at least 5 seconds and then turn
power back on. Within 60 seconds of restoring the power,
press and hold the fan SET button on the handheld remote
control for 5 seconds or until light kit (if installed) blinks
twice.
Test the fan functions to confirm the learning process is
complete--see Section 13 on the following page.
Select a faceplate (almond or white) and press firmly onto
front of wall control that was previously installed to the
outlet box on the wall. [Refer to diagram 1.]
Attach black faceplate to front of handheld remote
control; press down firmly. [Refer to diagram 2.]
diagram 1
page 10
IV
III
II V
VI
I
SET button
handheld
remote control
IV
III
V
II
VI
I
diagram 2
wall control
faceplate
(almond
or white)
OFF ON
faceplate
(black)
OFF ON
SET button