Marshalltown Bullet MS90-1909 Manual Del Propietário página 6

SAFETY LOCK
For maximum security, the safety lock will automatically
reset in the "locked" position unless disengaged. The
safety lock can be disengaged by sliding the knob over
and down, hooking into slot. (Shown Right)
TRANSPORT
CAM LOCK IN LOCKED POSITION
It is important to re-engage lock and secure unextended
handle in down position while storing, carrying, or
transporting your Magnum Edge Flooring Shear.
TIP: DOUBLE CUTTING
Most materials shear very well with just one cut.
However, some brands may require cutting twice to
produce a better cut.
CAM LOCK IN UNLOCKED POSITION
Simply make your first cut 1/8" to 1/4" (3 to 6mm) longer
than your mark, then go back and make your second
cut on your mark. This is very useful to create a cleaner
cut when a trim molding or transition cannot be used to
cover your cut end.
TIP:
If the groove of your planks splits when cutting, rip a
scrap piece and place it along side as a support.
THE ANVIL
The anvil has two edges: a 1/32" (0.75mm) narrow edge
and a 3/16" (4.5mm) wide edge. Either edge can be used
according to the support needed to make a clean cut
(some soft-backed products require the wider anvil
edge).
TABLE TABLE
TO CHANGE BETWEEN ANVIL EDGES
ANVIL
ANVIL
Simply remove the anvil screws and flip the anvil over.
I-BEAM I-BEAM
Ensure blade stop is in place.
6 of 14
WS2636
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com