Changing The Blade - Marshalltown Bullet MS90-1909 Manual Del Propietário

Required tools: 5/32" or 4mm hex key "Allen" wrench
1. TURN THE SHEAR UPSIDE DOWN
Tip: put the shear on the edge of a sturdy table.
2. LOOSEN THE BLADE
Using a 5/32" or 4mm hex key "Allen" wrench, remove the
Button Head Socket Cap Screws screws.
3. REMOVE BLADE
Hold blade by each end and carefully lift out of pocket.
4. INSTALL BLADE
Hold blade by each end and carefully place into the
blade pocket in the head, with the flat side of the blade
facing the table. Be sure that it is firmly seated, and the
pocket is clear of debris.
5. TIGHTEN THE BLADE
Using a 5/32" or 4mm hex key "Allen" wrench, replace
and tighten the screws, starting with the center screw.
LUBRICATING
Your Magnum Edge has been pre-lubricated with
grease under the end caps. Re-grease every 2 years of
use, or if the shear starts squeaking.
- Lock the handle down
- Lay your Magnum Edge on its side
- Remove the end cap by unscrewing the two button
head screws with a 5mm hex key "Allen" wrench
- Fill the grease cavity with grease
- Re-attach the end cap
- Repeat procedure on the other side
THE BLADE STOP
The blade stop may become worn. Remove anvil, turn
blade stop over for more use. Replacements can be
purchased at your dealer.
8 of 14
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

CHANGING THE BLADE

WARNING
!
USE EXTREME CAUTION! Blade is very sharp.
!
WS2636