Sensor Connection - Knick Stratos Eco 2405 Oxy Inicio Rápido

Sensor Connection

3
1 ESD shield covering the signal inputs (Screw off for assembly)
Note: The cable shield must end under the ESD shield. (Cut lines if required.)
2 Terminals for sensor
3 Power supply connection
4 Terminals for temperature probe and outer shield
5 Specifications for terminal assignment
Division 2 Wiring
The connections to the device must be installed
in accordance with the National Electric Code
(ANSI NFPA 70) Division 2 hazardous (classified)
location non-incendive wiring techniques.
4
2
4
1
5