Before Use - Euroflex monster EZ2-S Manual De Instrucciones

Before use

Make sure all parts are in the box (see pg 4). IMPORTANT: FOLLOW THESE INSTRUCTIONS CAREFULLY!
A. Assemble Handle
After removing Handle Assembly from carton:
• Pull Extension Tube apart (shown below).
• Snap connector down. When a "click" is heard, the Tube is locked in position.
"Maximum Extension" Position
IMPORTANT
Frontal steam can only be generated when Extension Tube is in the "Maximum Extension" position.
BE SURE EXTENSION TUBE IS FULLY EXTENDED AND LOCKED IN PLACE FOR OPTIMAL STEAM OPERATION.
Use Extension Tube in Collapsed position only with the Carpet Glide (when cleaning upholstery) or when storing.
B. Attach Handle to Steamer
• Before starting, remove the self-tapping screw from the bottom of Extension Tube.
• Insert the Handle Assembly into the Floor Steamer Base. Align Arrow on Handle with Arrow on Base (as shown in Fig. A).
• Once inserted, twist Handle Assembly 90° clockwise
(as shown in Fig. B). Be sure Arrow on the Handle is aligned
with Line/Lock Icon on Base.
Fig. C
• Align the Handle Assembly screw
hole with the opening in the steamer
housing.
Secure the handle assembly with
self-tapping screw which was
removed from bottom of Extension
Tube (as shown in Fig. C).
ASSEMBLY OF PASTS & PREPARATION OF STEAMER
Pull apart Extension Tube
1
2
Front View
• Extend Tube to the "Lock - I" position.
Fig. A
Side View
10
3
Fig. B
90°