Wiring; Important - Craftmade Swyft Guia De Instalacion

6. Wiring.

WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the diagram to the right, please use a
qualified electrician.
Note: Excess lead wire length from the fan can be cut to
the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, wire the RECEIVER with wire connectors
provided as shown in diagram at right.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into hanging
bracket.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push taped wire connectors into
outlet box. Allow antenna from remote control
receiver to hang outside of hanging bracket.
[PLEASE NOTE: Wall and/or handheld remote control
must be used for fan to operate. If you do not wish to
use the wall control, please proceed to Section 7 , page 7
continue with fan installation].
To install wall control, remove existing wall switch.
Wire one of the wall controls with wire connectors
provided as shown in diagram at right.
*Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires
and taped wire connectors into outlet box.
Install one 12-volt battery (included) in wall control.
IMPORTANT: Wall control will not function unless
battery is installed.
Since this fan comes with with a LED light kit, the
dimmer switch (labeled DIM and ON) has been
pre-set to the "ON" position (DIM). If you do not wish
to have dimming capability, please move the switch
to the "OFF" position (ON).
Select a faceplate (almond or white) and press firmly
onto front of wall control. Attach wall control to outlet
box and secure with screws from original wall switch.
Attach wall plate (included) to wall control using two
screws provided with the wall control.
white supply wire
black supply wire
blue
black
white
from fan
from receiver
white
black
blue
(wiring for receiver)
outlet box
green/
bare
ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
WARNING: Choking Hazard - Small parts.
Keep battery away from children.
page 6
ground (green
or bare)
from ceiling
from receiver
black
AC IN L
white
AC IN N
receiver
antenna
wall
control
-
1 1
- 2 2
green
DIM/ON
black (OUT to fan)
OFF
black
(TO power SUPPLY)
12V battery
ground (green
or bare)
black
*
dimmer
switch
face
plate
plate