Charging; Charging Current Limiting; Charging Current Limiting; Pausing - Porsche Wall Charger Connect Manual De Funcionamiento E Instrucciones De Instalación

Charging

Vehicle charge port

For information on connecting and disconnecting the
vehicle cable to and from the vehicle charge port and
for the charging and connection status at the vehicle
charge port:
f See Owner's Manual.
Electric shock, fire
DANGER
Risk of serious or fatal injury due to fire or electric
shock.
e Always observe the specified sequence for the
charging process.
e Do not disconnect the vehicle cable from the
vehicle charge port during the charging process.
e End the charging process before disconnecting
the vehicle cable from the vehicle charge port.
Errors are shown on the display and are indicated by
red status LEDs. Error message, cause and remedial
measure are displayed.
f Please see chapter "Malfunctions" on page 12.
Starting charging
Information
– Charging is controlled by the vehicle. The
charging process can only be stopped at the
vehicle.
– The charge status is shown on the display provided
the charger is not in standby mode. In standby
mode, the display can be switched on again by
pressing the Power button or the display itself.
In standby mode, the device can be switched on
again by pressing the Power button
– A high-temperature switch-off feature prevents
overheating while charging.
1. Insert the plug into the electrical socket.
Power button lights up white.
Status LEDs light up white.
The display switches on.
2. Insert the vehicle plug in the vehicle charge port.
Power button lights up white.
Status LEDs pulsate white.
Following a successful self-test and when the
connection is established, the status LEDs light
up white.
3. Charging starts automatically.
Power button lights up white.
Status LEDs pulsate green.
4. After a few minutes, the display switches
to standby mode.
The vehicle is charging.
f For information on connecting the vehicle
cable to the vehicle charge port, see the
Owner's Manual.
Pausing charging
Charging is controlled by the vehicle and may
occasionally be paused, e.g. in order to optimize
power consumption.
When charging is paused, this will be indicated
on the control unit:
Power button lights up white.
Status LEDs flash blue.
The display switches on.
The vehicle starts charging again automatically.
The charging process can be stopped at the vehicle.
.
Operating Instructions
Stopping charging
b Charging was completed successfully.
Power button lights up white.
Status LEDs light up green
The display switches on and shows information
about the completed charging process.
After a few minutes, the charger switches
to standby mode.
1. Disconnect the vehicle plug from the vehicle
charge port.
2. Lay the cable, without twisting it, around the Wall
Charger Connect and hang up the plug in the
parking position after charging.
Information
Improper use, in the form of torsion/twisting of the
vehicle cable while stretching or pulling on it, is to be
avoided.

Charging Current Limiting

The maximum available charging current is
determined by the I Sel rotary switch setting and is
set during installation by the qualified electrician.
The charger detects the voltage and the available
electric current automatically.
The charging current can also be reduced by other
electrical loads in the home network, e.g. by an
electric heater or water heater.
If you are unsure about this, contact a qualified
electrician.
The power to be used for charging can be set using
charging current limiting (S
ETTINGS
). The last charging current set is
CHARGING CURRENT
saved. The charging power must never be set higher
than the maximum available power of the electrical
circuit used.
US
FC
ESM
> A
DJUST
11