Cleaning And Maintenance; Problems And Solutions - tomado TGH6001S Instrucciones De Uso

Clean the hob after each use to maintain it in good condition. Food residue can create stubborn stains if not removed directly
after use. Use a mild cleaning detergent to clean the hob.
Burner parts and the pan supports should not be cleaned in the dishwasher. The dishwasher detergent can corrode the materials.
The pan supports, burners and burner caps are removable for easy cleaning of the cooking part.
• First clean the control knobs, burners, burner caps and pan supports.
• Check whether the thermocouple and ignition are clean. If necessary use a toothpick or needle.
• Clean the drip tray.
• Clean everything again with just a damp cloth and dry it thoroughly.
• Refit the burners. Make sure the openings are aligned for the thermocouple and the ignition.
• Refit the burner caps.
• Refit the pan supports. Place them carefully on the drip tray without sliding.
PERSISTENT STAINS
Persistent stains on the pan supports and burner caps can best be removed with a fluid detergent or a plastic scouring sponge.
Never use aggressive cleaning products or sharp objects to clean the hob.
Persistent stains on stainless steel are best removed with a special stainless steel cleaning product. Always wipe in the direction
of the grain to prevent damage to the protective layer.
The surface of the stainless steel drip tray can discolour slightly over time.
If the hob does not function properly, according to you, please try to solve the problem first by checking the points in the table
below before contacting the customer department.
Fault Possible cause
There is The hob connection is leaking.
a smell of gas
near the hob.
A burner does • The plug is not in the socket.
not ignite. • A fuse is defective/ or switched
off in the fuse box.
• Ignition is dirty/damp.
• The burner parts are not placed
correctly.
• The burner parts are dirty/
damp.
• The main gas suplly valve
is closed.
• A fault in the gas mains.
• Wrong type of gas used.
The burner • The control knob has not been
extinguishes pressed long and/or deep
immediately enough (at least 3 seconds).
after igniting.
• The thermocouple is dirty.
The burner • The burner parts are not placed
does not burn correctly.
evenly. • The burner parts are dirty/
damp.
• The wrong type of gas is used.

CLEANING AND MAINTENANCE

PROBLEMS AND SOLUTIONS

Solution
Turn off the main gas supply valve. Contact your installer.
• Put the plug into the socket.
• Replace the fuse or switch on the fuse in the fuse box.
• Clean/dry the ignition.
• Refit the burner and watch the openings for the thermocouple and the
ignition.
• Clean/dry the burner parts.
• Open the main gas valve.
• Consult your gas supplier.
• Check whether the gas used is suitable for the appliance. Contact your
installer if it is not correct.
• Keep the control knob fully pressed for at least 3 seconds between the
highest and the lowest flame setting. This can take longer the first time
because of the gas supply.
• Clean/dry the thermocouple.
• Refit the burner and watch the openings for the thermocouple and the
ignition.
• Clean/ dry the burner parts.
• Check whether the gas used is suitable for the appliance. Contact your
installer if it is not correct.
EN - 24