Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
switch. With the impact driver held in normal
operating position: position the direction-
of-rotation selector to the left of the tool for
forward rotation; position the direction-of-rota-
tion selector to the right of the tool for reverse
rotation. Setting the switch in the OFF (center-
lock) position helps to reduce the possibility of
accidental starting when not in use.
NOTICE: To prevent gear damage, always allow
the impact driver to come to a complete stop
before changing the direction of rotation.
NOTICE: The impact driver will not run unless
the direction of the rotation selector is engaged
fully to the left or right.
MODE SELECTOR (FIG. 4)
NOTICE:
The
impact driver is
designed
with
3-speed and auto-
stop
functions;
these
functions
are available only
when the tool is
operating in for-
ward rotation.
NOTICE: The mode can only be changed when
the mode-indicator light is on. The mode-indica-
tor light will be off automatically in about one
minute.
1. Attach the battery pack to the impact driver.
2. Position the direction-of-rotation selector to
the left of the tool for forward rotation, and
press the trigger switch to turn on the mode-
indicator light.
3. Press the mode selector to change the speed:
press once for low, press twice for medium, and
press a third time for high.
4. To make the Auto-stop function available,
press and hold the mode selector for three sec-
onds: the autostop indicator will shine. When a
bolt/ nut is sufficiently tightened, the tool will
automatically stop the impact and rotation after
approximately one second.
5. To turn off the auto-stop function, press and
hold the mode selector for three seconds again.
The auto-stop indicator is will turn off.
ELECTRIC BRAKE
The impact driver is equipped with an electric
brake. When the trigger switch is released, the
electric brake engages automatically to quickly
stop the rotation.
LED WORKLIGHT RING (FIG.5)
The LED worklight rings, located around the
E N G L I S H •
shaft of the im-
pact driver, will
illuminate
when
the trigger switch
is
depressed.
This provides ad-
ditional light on
the
surface
of
the
workpiece
for operation in
lower-light areas.
The light will automatically turn off within 10
seconds after the trigger is released.
INSTALLING THE BELT CLIP (FIG. 6)
1. Align the rib
of the belt clip
with the hole on
the base of the
wrench.
2. Insert the screw
and tighten the
screw
securely
with a screwdriver
(available
sepa-
rately).
REMOVING THE BELT CLIP
1. Remove the battery from the tool.
2. Use a screwdriver to loosen the screw that at-
taches the belt clip to the driver.
3. Remove the screw and the belt clip.
TO INSTALL THE BIT HOLDER (FIG.7)
1.
Remove
the
battery from the
tool.
2. Align the rib
of the bit holder
with the hole in
the base of the
impact driver.
3. Insert the screw
(included)
and
securely
tighten
the screw with a screwdriver (not included). The
bit holder can be positioned on either side of
the tool.
To remove the bit holder:
1. Remove the battery from the tool.
2. Use a screwdriver to loosen the screw
that attaches the bit holder to the impact driver.
3. Remove the screw and the bit holder.
INSTALLING BITS (FIG.8)
1. Lock the trigger switch on the impact driver
U s er 's M an u al
14
Publicidad
Tabla de contenido
