Molnlycke Mepilex Lite Manual Del Usuario página 5

Mepilex Lite
®
Soft silicone foam dressing
Product description
Mepilex Lite is a highly conformable dressing that absorbs exudates,
maintains a moist wound environment and minimises the risk for maceration.
The dressing has a Safetac wound contact layer that is a unique adhesive
®
technology. It minimises pain to patients and trauma to wounds and the
surrounding skin at dressing removal.
Mepilex Lite consists of
• a soft silicone wound contact layer (Safetac)
• a thin, flexible absorbent pad of polyurethane foam
• an outer polyurethane film which is breathable but waterproof
Dressing material content:
Silicone, polyurethane
Indications for use
Mepilex Lite is designed for the management of a wide range of non to low exuding
wounds such as leg and foot ulcers, pressure ulcers, partial thickness burns,
radiation skin reactions and Epidermolysis Bullosa. Mepilex Lite can also be used as
a protection of compromised and/or fragile skin.
Precautions
• Do not use on patients with known hypersensitivity to the dressing or its materials.
• Do not use together with oxidising agents such as hypochlorite solutions or
hydrogen peroxide.
• If you see signs of clinical infection e.g. fever or if the wound or surrounding skin
becomes red, warm or swollen, consult a health care professional for appropriate
treatment.
• Do not reuse, if reused performance of the product may deteriorate and cross
contamination may occur.
• Sterile. Do not use if sterile barrier is damaged or opened prior to use.
Do not re-sterilise.
Instructions for use
Mepilex Lite can be used by laypersons under the supervision of health care
professionals.
1. Cleanse the wound in accordance with clinical practice.
2. Dry the surrounding skin thoroughly.
3. Select an appropriate dressing size. The dressing should cover the dry
surrounding skin by at least 1-2 cm for small sizes (sizes up to 12.5x12.5 cm)
and 3-5 cm for large sizes. If required, the dressing may be cut to suit various
wound shapes and locations.
4. Remove the first release film and apply the adherent side to the wound.
5. Remove the remaining release film and smooth down the dressing on the skin.
Do not stretch the dressing.
6. When necessary, fixate the dressing with a bandage or other fixation.
The dressing change interval may be several days. Change the dressing before
it is fully saturated, at signs of leakage, or as indicated by clinical practice.
Mepilex Lite can be used under compression bandaging and in combination
with gels.
Disposal should be handled according to local environmental procedures.
Other information
The polyurethane foam used in the product may change colour to more yellow when
it is exposed to light, air and/or heat. The colour change has no influence on product
properties when used before expiry date.
If any serious incident has occurred in relation to the use of Mepilex Lite, it should
be reported to Mölnlycke Health Care.
Mepilex and Safetac are registered trademarks of Mölnlycke Health Care AB.
® ®