Parking Brake; Adjusting The Backrest - Foppapedretti MYO Manual De Instrucciones

GB
USE
the swiel wheels on normal road surfaces as it makes it easier to manoueuvre.

PARKING BRAKE

To apply the brake (fig. 29): Press the brake lever "black", push the pushchair forward gently to
ensure the brake has been applied correctly.
To release the brake (fig. 30): Press the brake lever "blue".
WARNING: Always operate the brakes when the pushchair is still or when you place baby in or take
baby out of the pushchair.
ADJUSTING THE HANDLEBAR (fig.31)
The handlebar has two positions. Lift the regulating lever "A" and turn the handlebar as shown by
the arrow in the figure, to adjust it to the required position.
ADJUSTING THE FOTTREST (fig. 32)
Press buttons "A" and adjust the footrest in the required position.
ADJUSTING THE HOOD (fig.33, 34, 35)
Extend the hood according to requirements to protect baby from the sun.
Note: babie's skin is very delicate. NEVER leave baby under direct sunlight. Always make sure that
the hood has been adjusted correctly.
Ventilation (fig. 35): Open the zip or the viewing window, according to the model purchased, to
ventilate the inside of the pushchair.
ADJUSTING THE DIRECTION OF THE SEAT (fig.36)
ATENTION: In order not to compromise the stability of the product, during the operations
described below, the pushchair should be placed on a flat surface and any weight hanging from
the handlebar must be removed.
Operate the parking brake before turning the seat.
At the same time pull both the levers releasing the seat outwards and then turn the seat by 180°.
A click will show that the seat has been locked in the new position.
WARNING: Always make sure that the seat has been secured correctly in the forward or rearward
facing position. The seat can be adjusted in the rearward or forward facing positions. NEVER use
the seat in any other position or if it has not been secured correctly.

ADJUSTING THE BACKREST

Reclining the backrest (fig.37): Lift the adjustment lever "A", located on the back of the backrest
and recline the backrest to the position required, release the lever and make sure the backrest has
been secured correctly in place.
Lifting the backrest (fig.38): Lift the backrest to the required position, without pressing the lever.
MYO 26