Operation - Hinkley HAMPTON Manual De Instrucciones

OPERATION

Your DC brushless motor is equipped with an
automatically learned type remote control.
There is no frequency switches on the receiver
or transmitter. The fan can start to use once
the pairing process is done.
Remove the panel from the transmitter and
then install one 23A/12V battery (included). To
prevent damage to transmitter, remove the
battery if not use for long periods of time (Fig.
16).
1
I, II, III, IV, V and VI button:
These six buttons are used to set the
fan speed as follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
2
button:
This button turns the fan off.
3
Reverse button:
This button is to control fan direction.
This button must be pressed while fan is
running (suggested speed IV)
4
Light button:
This button is to control optional light.
1
Switch the "D" and "ON" dip switch on the
front of transmitter to decide the light in
"ON/OFF" or "Dimmable" condition.
2
3
4
5
"SET" code setting button:
Follow the below steps to use the set
button. (Fig. 1)
6
ON - OFF Slide button: Power switch.
(Fig. 2)
7 Signal light (Fig. 2)
Pairing Process
With the fan's power off, restore power to the
fan. Press and hold "SET" button for about 5
seconds and release. If optional light kit is
installed, the light kit will flash twice and the
signal light on the wall control will come on
when the button is pressed. The fan has
completed the pairing process with the wall
control and is ready for use.
NOTE: A single fan can be controlled with as
many as 3 wall controls in one room. Every
control will need to repeat the pairing process
based on instructions above and all controls
must be within 30 feet of the fan.
Fig. 1
Signal light
Power switch
Fig. 2
©2020 Hinkley Lighting, Inc. | hinkley.com |
13